AV when opening new query since build .57

Erik van Putten · Post by **Erik van Putten** » Sun 27 Jun 2010 15:29

SDAC works fine for me up to release .56
If I open a new query (with others already open) in some of my programs I will get an AV error.

This is true for build .57, .58 and .59
I see in the release notes that an AV problem has been fixed going from .56 to .57, I think that fix causes the new AV problems.

Can I send anything to show the error. It happens the moment I execute a new query, a sample is hard to give because it happens only in a few of my programs when they are already very busy opening multiple query's.

(I've ordered the source in the hope that then I can pinpoint where the AV error comes from, the current AV is very hard to pinpoint although I use Eurekalog as well.)

(Working with Delphi 2010 BTW)

Regards Erik.

Dimon · Post by **Dimon** » Tue 29 Jun 2010 10:22

Unfortunately, the information you have provided is not enough to reproduce your issue.
Please simplify your application to maximum possible extent and send it to dmitryg*devart*com.