Devart Forums

Hello,
I am comparing the data to two database and then build the project file.
Control areas, these areas did not change the database each time edililiyor why?
Direct comparison can not be done? entered via the setup options
Because it takes time to check the settings. Bitecekken a 5-minute process ends in 1 minute.

For Example results

Describing objects...OK Always why you need it
Mapping objects...OK Always why you need it
Comparing data...OK only always checked

Thanks

Once a *.dcomp data comparison document is generated you can open it next time with no need to select/unselect the options again since the *.dcomp stores all the settings you specified previously when saving it.

Please note that the databases specified in the *.dcomp file are recompared each time you the file since it does not contain data comparison results, but stores the following information:

- Source and target settings
- Selected objects and subobjects
- Comparison keys
- Results filter
- Skipped objects

Please refer to the 'Saving and Loading Data Comparisons' topic in the product's Help documentation for details.

Also, you could automate data comparison and synchronization with the help of the command line interface of the product. Please see the 'How To: Compare and Synchronize Data through Command Line' topic in the Help documentation and the following articles on our website:

http://blogs.devart.com/dbforge/how-to- ... ndows.html
http://www.devart.com/dbforge/mysql/stu ... ackup.html