6.4.14 setup in xe8 found error
Posted: Sat 10 Sep 2016 02:38
Thanks
Thanks
Devart Forums
Discussion forums for open issues and questions concerning database tools, data access components and developer tools from Devart
https://forums.devart.com/
6.4.14 setup in xe8 found error
Page 1 of 1
Thanks
Re: 6.4.14 setup in xe8 found error
Posted: Tue 13 Sep 2016 05:55
The most possible reason for such behavior is presence in the system of the previous module versions distributed with UniDAC. To solve the issue with UniDAC, please try the following:
- close Delphi XE8;
- remove UniDAC;
- remove all *dac*.bpl and crcontrols*.bpl files from your computer (please make sure there are no such files on your computer);
- find all DAC units, like CRParser.dcu, CLRClasses.dcu, MemData.dcu, MemDS.dcu, DBAccess.dcu, OLEDBAccess.dcu files on your PC and delete them;
- install UniDAC
- close Delphi XE8;
- remove UniDAC;
- remove all *dac*.bpl and crcontrols*.bpl files from your computer (please make sure there are no such files on your computer);
- find all DAC units, like CRParser.dcu, CLRClasses.dcu, MemData.dcu, MemDS.dcu, DBAccess.dcu, OLEDBAccess.dcu files on your PC and delete them;
- install UniDAC
Re: 6.4.14 setup in xe8 found error
Posted: Fri 16 Sep 2016 05:30
Thanks
is ok.
is ok.
Re: 6.4.14 setup in xe8 found error
Posted: Tue 20 Sep 2016 08:12
It is good to see that the issue has been solved.
Feel free to contact us if you have any further questions about our products.
Feel free to contact us if you have any further questions about our products.