Page 1 of 1
Many errors after installation unidac :-(
Posted: Fri 28 May 2010 08:20
by Schorsch
Hi. After the installation of unidac for delphi 7 delphi will start with many errors:
- "@memutils@initialitation$qqrv" in the DLL dac70.bpl not found
- etc.,etc.etc.
The bin and lib-path are set correctly in the environment!
Please help..
Posted: Fri 28 May 2010 14:58
by bork
Hello
Problem is that UniDAC has been installen with errors. Please check if folder "D:\Program Files\Devart\UniDac for Delphi 7\" has been created. Also please check that files dac70.bpl, dacvcl70.bpl, datasetmanager70.bpl, etc. is located in the folder "D:\Program Files\Devart\UniDac for Delphi 7\Bin\". If this folder was not created or files are missing then please check permissions. Maybe you don't have enough permissions in the folder "D:\Program Files\".
So I can recommend two ways:
The first one:
- Login to Windows with administrator permissions
- Uninstall UniDAC components: Start -> Settings -> Control Panel -> Add or Remove Programms -> Devart UniDAC for Delphi 7
- Install UniDAC components again
The second way:
- Uninstall UniDAC components: Start -> Settings -> Control Panel -> Add or Remove Programms -> Devart UniDAC for Delphi 7
- Install UniDAC components to other folder where you have enough permissions for creating folders and files
Posted: Mon 31 May 2010 07:51
by Schorsch
Hi,
all files exists under programs.. but I have reinstalled the components (with reboot)
THE SAME PROBLEMS!!!
I have all rights and the installation brings NO errors! I have on my pc installed unidac for delphi 2010 too - is this the problem??
Please.. - its urgent!
Tks..
Posted: Mon 31 May 2010 08:29
by Schorsch
STOP - it runs! There was older files in the delphi-folders
Tks..
Posted: Mon 31 May 2010 08:52
by bork
It is good to see that this problem has been solved. If any other questions come up, please contact me.