Devart Forums

Hi,
I have installed MyDev and wanted to debug some procedures I have. It all worked fine till today, when I started getting an error message when I debug:
"Result consisted of more than one row". I thought it's something wrong i my code, but normal execution (without debug) worked fine.
So, I wrote a new small procedure with 1 line, and always I get this error.

Please advise,

Regards,
Dinka

rdrbnhd wrote:Hi,
I have installed MyDev and wanted to debug some procedures I have. It all worked fine till today, when I started getting an error message when I debug:
"Result consisted of more than one row". I thought it's something wrong i my code, but normal execution (without debug) worked fine.
So, I wrote a new small procedure with 1 line, and always I get this error.

Please advise,

Regards,
Dinka

It's a known problem and we are working on it. Just redeploy the debug engine and everything will be ok.

Is it also known that when putting a label on a loop (e.g. while loop) debug fails?

Regards,
Dinka

rdrbnhd wrote:Is it also known that when putting a label on a loop (e.g. while loop) debug fails?

Regards,
Dinka

Now we know about it.

We have fixed the problem with "Result consisted of more than one row" message during debugging. The fix will be available in the next build.