Cannot debug procedures

rdrbnhd · Post by **rdrbnhd** » Wed 02 Apr 2008 09:19

Hi,
I have installed MyDev and wanted to debug some procedures I have. It all worked fine till today, when I started getting an error message when I debug:
"Result consisted of more than one row". I thought it's something wrong i my code, but normal execution (without debug) worked fine.
So, I wrote a new small procedure with 1 line, and always I get this error.

Please advise,

Regards,
Dinka

Elias · Post by **Elias** » Thu 03 Apr 2008 08:36

rdrbnhd wrote:Hi,
I have installed MyDev and wanted to debug some procedures I have. It all worked fine till today, when I started getting an error message when I debug:
"Result consisted of more than one row". I thought it's something wrong i my code, but normal execution (without debug) worked fine.
So, I wrote a new small procedure with 1 line, and always I get this error.

Please advise,

Regards,
Dinka

It's a known problem and we are working on it. Just redeploy the debug engine and everything will be ok.

rdrbnhd · Post by **rdrbnhd** » Thu 03 Apr 2008 09:16

Is it also known that when putting a label on a loop (e.g. while loop) debug fails?

Regards,
Dinka

Elias · Post by **Elias** » Thu 03 Apr 2008 09:31

rdrbnhd wrote:Is it also known that when putting a label on a loop (e.g. while loop) debug fails?

Regards,
Dinka

Now we know about it.

Elias · Post by **Elias** » Mon 03 Nov 2008 16:30

We have fixed the problem with "Result consisted of more than one row" message during debugging. The fix will be available in the next build.

Devart Forums

Cannot debug procedures

Cannot debug procedures

Re: Cannot debug procedures

Thanks, plus another question

Re: Thanks, plus another question