two bugs in "edit procedure"

[xb151652000]

i have some big procedure over 5000 lines, when i want to edit it, i will use "Edit Procedure", but i meet two BUGS in new version(7.1.13)。

1. when i add any words in the procedure at anywhere (even a space), the "Edit Procedure" will throw a error "It is impossible to switch to the Design mode. An object has incorrect source code", and i conn't use
"Update Database" to finish my change
2. when i add any words in the procedure, the dbForge will not response in few seconds

[alexa]

Could you please provide us the CREATE definitions of the procedures and describe the steps to reproduce the issues in detail?

You can reply straight to our support system at supportATdevartDOTcom