Devart Forums

I have acquired recently the 610 version of mySQl Dot connect.
My proyects was designed on VS2008, waiting for the connector for VS2010, then now I have installed the VS2010 and the new Dot Connect with support to VS2010, then i have migrated my proyects to VS2010, but i have errors on conection to data like "Cannot obtain provider factory for data provider named 'Corelab.mySQL'".
I remark that the same proyects under VS2008 using the same connector (610) run with no problems.

Can you help me ASAP ?


Juan Carlos Flores
Choluteca, Honduras

P.D. The proyects has been converted from VS2008 to VS2010 used the VS2010 tool.

As far as I know, is no more 'CoreLab.MySQL'; is now 'Devart.Data.MySQL'
You must check you're pointing to the right library...
Also, did you run the Devart Upgrade Wizard?

Suerte!!

Thks a lot for your answer.

Where can i find the Devart Upgrade wizard ?.


Juan Carlos Flores
Choluteca, Honduras

juanka_hn wrote:Thks a lot for your answer.

Where can i find the Devart Upgrade wizard ?.

Sure, under: Toos > MySQL > Upgrade Wizard...

Of course, it depends on your VS language.

iDave, thank you for posting.

juanka_hn, please refer to http://www.devart.com/dotconnect/mysql/ ... Q.html#q21.